Replacement sensor for your aem O2 wideband controller
AEM's Bosch 4.2LSU Wideband UEGO O2 replacement sensor kit includes only the sensor (with attached cable and male connector) and is intended to replace an existing mounted wideband sensor used with AEM wideband air/fuel UEGO controllers.
These sensors have a laser-etched, calibrated resistor in the sensor’s connector body. This resistor is specifically created for the exact sensor that it is attached to. Modifying this will invalidate the sensor’s output. The wideband sensor is laboratory-calibrated at the Bosch factory, accurate to 0.1 AFR and never requires free-air calibration when used with an AEM wideband AFR controller.
- Accurate to 0.1 AFR
- Never requires free-air calibration when used with an AEM Controller and connector plug.
- Specifically designed for use with AEM Wideband UEGO controllers
- Replacement sensor only
Replacement Sensor for the following AEM Wideband Controllers.
- AEM Infinity Engine Management Systems
- 30-4100 - Digital Wideband UEGO Gauge
- 30-4900 - Wideband Failsafe Gauge
- 30-2310 - Inline Wideband UEGO Controller
- 30-2340 - 4-Channel Wideband UEGO Controller
- 30-2340-N - 4-Channel Wideband UEGO Controller - Nascar
- 30-5130 - Analog Wideband UEGO Gauge
- 30-5143 - Analog E85 Wideband UEGO Gauge
- 30-2320 - X-WiFi Wideband/EGT Controller
For Digital Wideband UEGO Controller Part Number 30-4110 please refer to the 30-2004 Bosch LSU 4.9 Replacement UEGO Sensor PN 30-2004.
- Unknown Type
- Cat Back Exhaust
- catch can
- coolant expansion tank
- Cylinder Heads
- Flex Fuel Kit
- Full Exhaust System
- Gift Card
- Meth System
- Plug Wires
- Stage 1 Package
- Stage 2 Package
- Stage 3 Package
- Stage 4 Package
- Stage 5 Package
- throttle body
- Washer Reservoir